Hi,

This is CADian.

We have prepared 400+ Lisp programs to aid your CAD experience, free of charge!

Full List of all CADian Lisps : [Full CADian Lisp List]

How to Install : [CADian Lisps Download & Install Guide]

====================================================

1/ Command :

• ACL

2/ Description :

This tool allows you to automatically draw a base set of cross-hair centerlines and then rapidly add multiple concentric circles (either visible outlines or circular centerlines) around a single center point.

• Auto-Sizing : The initial centerlines are automatically drawn slightly larger than the largest diameter you specify.

• Layer Control via Prefix : You can easily switch between drawing a normal circle (Layer 0) and a circular centerline (Layer Center) by adding a prefix to your input

3/ How to Use:

1. Type ACL in the command line and press Enter.

2. Click the Center Point for the circles.

3. Enter the Diameter for the main cross-hair centerlines (typically the size of your largest intended circle).

• Example: Type 100 and press Enter. The cross-hairs are drawn to fit a 100mm circle.

4. Add Concentric Circles:

• For a Normal Circle (Layer 0): Type the diameter starting with 0.

• Example: 050 -> Draws a 50mm circle on Layer 0.

• Example: 085 -> Draws an 85mm circle on Layer 0.

• For a Centerline Circle (Layer Center): Type C followed by the diameter.

• Example: C70 -> Draws a 70mm circle on the CENTER layer.

• Example: C100 -> Draws a 100mm circle on the CENTER layer.

5. Press ESC to finish.